_15
3
18
_07
EN
SAFETY INFORMATION
3.3 Safety signal description
• To ensure safe operation please read the following
statements and understand their meaning.
• Also refer to your equipment manufacturer's manual for
other important safety information.
• This manual contains safety precautions which are
explained below.
• Please read them carefully.
Read the Operation and Maintenance handbook before
performing any operation on the engine.
Hot Parts.
Danger of burns.
Presence of rotating parts.
Danger of jamming or cutting.
Presence of explosive fuel.
Danger of fire or explosion.
Presence of steam and pressurized coolant.
Danger of burns.
Use protective gloves before carrying out the operation.
Use protective glasses before carrying out the
operation.
Use sound absorbing protections before carrying out
the operation.
Lifting point.
Electrical shock.
Danger of severe scalding or death.
High pressure fluid.
Danger of fluid penetration.
Lethal Exhaust Gases.
Danger of poisoning or death.
3.3.1 Adhesive safety plates
The following is a list of the adhesive safety plates that may
be found on the engine, which indicate potential points of
danger to the operator (Par. 3.6).
3.3.2 Safety guards
Hereunder is a list of safety guards that must be worn prior
to carrying out any type of operation and to avoid potential
harm to the operator.
3.3.3 Warnings
Hereunder is a list of safety warnings that may be found in
the manual, which advise you to pay attention when carrying
out particular procedures that may be potentially dangerous
to the operator or things.
Danger
• This indicates situations of grave danger which, if ignored,
may seriously threaten the health and safety of individuals.
Important
• This indicates particularly important technical information
that should not be ignored.
Warning
• This indicates that failure to comply with it can cause minor
damage or injury.
ED0053030050
To Next Page
Loading...
Need help?
General