INFORMATION ABOUT USE
4
27
EN
Internal Communication: For internal & partner use only.
4.5 Oil filling
•
For safety precautions see Par. 2.4.
•
Before proceeding with operation, read Par. 3.2.2.
•
Do not use the engine with the oil level below the minimum.
1.
Loosen the oil filler cap A.
2.
Add the type and amount of oil recommended (Tab. 2.1 and
Tab. 2.2).
3.
Before checking oil engine needs to be level.
4.
Remove the oil dipstick B and check that the level is up to but
does not exceed the MAX.
5.
If level is not at the MAX . level, add additional oil.
6.
Re-tighten the cap A.
NOTE : Click on the right to play the procedure.
https://youtu.be/AKB8FW8k5rY
4.6 Coolant filling
Important
• Before proceeding with operation, read Par. 3.2.2.
Warning
• An anti-freeze protection liquid (ANTIFREEZE) - mixed with decalcified water - must be used.
• The freezing point of the refrigerant mixture depends on the amount concentration in water.
• As well as lowering the freezing point, the antifreeze also raises the boiling point.
• A 50% mixture is recommended to ensure a general level at protection prevents the formation of rust,
galvanic currents and calcium deposits (Tab. 2.4).
To Next Page
Loading...
Need help?
General