TP-6928 1/14 29Section 2 OnCue Plus Operation
2.11.2 Stop Exercise
After starting the engine using the Start button, click on
Stop to stop the engine before the programmed stop
time, if necessary. The generator set controller must be
in AUTO mode for remote start/stop using OnCue Plus.
Note: The Stop Exercise command will not stop the
generator set if it was started a t the controller by
pressing RUN, by a remote start command from
an ATS, or by a scheduled exercise set at the
controller.
1
1. Click Stop to shut down the generator before the exercise time expires. This only stops an exercise that was initiated by clicking the
START button in OnCue Plus.
Figure 2-15 Controls, Stop Exercise
To Next Page
Loading...
Need help?
General
