72
16. Connect piggyback terminals of the motor control wire assembly to the tabs of the hot gas
valve on the ice maker.
17. Reconnect the white plug assembly to the piggyback terminals of the motor control wire
assembly as shown below.
18. Locate the bin thermostat of the ice machine and cut the probe off of the end of the cable
19. Route the cable through one of the small holes in the bottom of the ice machine and into
the back of the crusher control box
20. Pull the cable out through the front of the crusher control box and cut off the cable to a
manageable length.
21. Strip the outer cable jacket back about 3”. Then strip the red and black wires back about ¼”.
22. Connect the stripped wires to the left relay as shown.
To Next Page
Loading...
