16
Timer
The timer can be used to either turn the unit on or off after a number of elapsed hours. The timer is
adjustable between 1-24 hours in one hour increments.
How to set the unit to automatically turn on:
1. Press the Timer button while the unit and remote are powered off. The On Timer [ ]
indicator will be selected and the timed hour indicator will be blinking.
2. Use the Up and Down buttons to set the number of hours you want to pass before the
unit turns on.
3. Press the Timer button again to set the timer. The timed hour indicator will stop blinking. After
the selected time passes, the unit will automatically turn on.
How to set the unit to automatically turn off:
1. Press the Timer button while the unit and remote are powered on. The Off Timer [ ]
indicator will be selected and the timed hour indicator will be blinking.
2. Use the Up and Down buttons to set the number of hours.
3. Press the Timer button again to set the timer. The timed hour indicator will stop blinking. The
unit will automatically turn off after the selected time elapses.
Front Panel Lights and Controls
Front Panel Lights
Your portable air conditioner has a front panel that lights up different colors depending on the mode it is
running in.
Cooling mode will display a blue light.
Dehumidify mode will display a yellow light.
Fan mode will display a green light.
Heating mode (on certain models) will display a red light.
Automatic mode will display the color of the automatically selected current mode.
If the unit flashes a red light and the unit stops cooling, this indicates that the internal water reservoir is
full. Place a pan under the unit, and remove the drain plug to drain the unit.
If the lights flash from left to right and the unit does not work, contact customer service.
Front Panel Controls
The front panel has an emergency power switch. The power switch can be used when the unit needs
to be shut off or turned on without the remote control.
You can turn off the front panel lights by hitting the Lamp Off switch.
To Next Page
Loading...
Need help?
General
