16
Error Codes
AS - Room temperature sensor error
Unplug the unit and plug it back in.
If the error repeats call for service.
Note- In Fan only mode it will display “LO” or “HI”.
- Evaporator temperature sensor error
Unplug the unit and plug it back in.
If the error repeats, call for service.
HS - Electric Heating sensor error
Unplug the unit and plug it back in.
If the error repeats, call for service.
Air Directional Louvers:
The 4-way air directional louvers allow you to direct the air flow Up, Down, Left, and Right
throughout the room as needed. To adjust the air directional louvers side to side use the center
handles as you move side to side. To pivot the louvers, press with your fingers until the desired
airflow direction is obtained.
Additional Tips:
The “Cool” mode has an automatic 3 minute timed delay start if the unit is turned off and on
quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The
fan will continue to run during this time.
The unit is capable of displaying the temperature in degrees Fahrenheit or degrees Celsius. To
convert from one to the other, press and hold the Up and Down Temp / Timer buttons at the
same time for 3 seconds.
To Next Page
Loading...
Need help?
General
