II.3 Commissioning
II.3.1 Important instructions
n
Check that the instructions in Chapter II.1 have been followed.
n
The correct step-by-step procedure for commissioning will help you to avoid causing any
damage. If you require further information, please get in touch with our applications
department.
n
Controller setting, optimisation, and the configuration of circuit blocks by using the solder
links is permitted.
Any further manipulation will invalidate the guarantee.
n
Never connect or disconnect the modules when the system is live
This is vital to avoid burning out contacts, or even destroying entire circuit modules in
the controller, and to avoid personal danger from fully charged capacitors.
Residual charge in the capacitors can still have a dangerous level more than 120 sec.
after switching off the mains supply.
Connect or disconnect the controller only when the voltage is below the minimum
threshold level. Watch the LEDs in the controller after the supply voltage has been
switched off. After a short time the green LED will go out and the red LED will light up
briefly. Now you can pull out or plug in the controller.
n
Push the module carefully and completely into the rack housing, to ensure that the
connectors make a good contact. Poor contact will lead to contact burnout.
Page II - 8 Installation and Commissioning Chapter II
Series 04S 12.99 Kollmorgen
To Next Page
Loading...
Need help?
General