Sta
n
-
dar
ds
an
d
Di
-
rec
tive
s/
CE
Page - D - Standards and Directives / CE
Series 04S 12.99 Kollmorgen
Standards and Directives
Transistor controllers are components which are intended to be installed in electrical equipment
and machinery.
When the transistor controllers are incorporated into equipment or machinery, then the start of
prescribed usage is prohibited until it has been confirmed that the equipment/machine fulfils the
requirements of the EC Directive on Machines 89/392/EEC, the EC EMC Directive (89/336/EEC)
and the EC Low Voltage Directive 73/23/EEC.
EN 60204 and EN 292 must also be observed.
The Low Voltage Directive 73/23/EEC does not apply to the 04S amplifier, because of the low
rated voltage.
The manufacturer of the equipment or machine is responsible for ensuring that it meets the limits
which are laid down by EMC regulations. Advice on the correct installation for EMC – such as
shielding, grounding, arrangement of filters – is included in this documentation.
-conformance
Conformance with the following Directive is mandatory for the supply of transistor controllers
within the European Community:
since 01 January 1996 : EC EMC Directive 89/336/EEC
The 04S series of transistor controllers have been tested in an authorised testing laboratory, in a
specified configuration with the system components as shown in Chapter II.
Any divergence from the configuration and installation which are described in the documentation
means that you will yourself be responsible for carrying out new measurements to ensure that the
regulatory requirements are fulfilled.
To Next Page
Loading...
Need help?
General