4 Servomotors AKM
05/2006 Kollmorgen
Manufacturer declaration
According to the EG-Machine-guideline 98/37/EC, appendix II B
We, the company
Danaher Motion GmbH
Wacholderstrasse 40-42
40489 Düsseldorf
declare, that the product
Motor series AKM
(Types AKM1, AKM2, AKM3, AKM4, AKM5, AKM6, AKM7)
is intended exclusively, in its standard version, for installation in another machine and that its setup is forbid
-
den until it has been established that the machine into which this product is to be installed conforms to the pro
-
visions of the EC Directive in its version 98/37/ECW.
We confirm that the above-mentioned product conforms to the following standards:
73/23/EEC Low voltage directive
VDE 0530 / DIN 57530 Provisions for rotating machinery
DIN EN 60034-7 Design
DIN 748 Cylindrical shaft ends
DIN 6885 Keyway and Key
DIN 42955 True running, coaxiality and concentricity
DIN EN 60034-14 Vibration class
Issued by: Management
Michel van Roozendaal
This Declaration does not contain any assurance of properties. The notes on safety and protection in the ope
-
rating instructions must always be observed.
To Next Page
Loading...
Need help?
General
