Kolver EDU 2AE/TOP/TA - Introduction and Table of Screwdriver Models

Vers. 270921 Page 2
EDU 2AE/TOP power supply and control units are an innovative system for controlling the torque of any
current control MITO and PLUTO electric screwdrivers: MITO15, PLUTO 3, PLUTO 6, PLUTO 10,
PLUTO 15, PLUTO 20, PLUTO 30, PLUTO45, PLUTO50 and PLUTO70, either inline, pistol, push to
start, for automation and with angle head (only PLUTO).
EDU 2AE/TOP delivers all the advantages of precision torque control electric tools at a fraction of the price
of transdurized tools.
The state-of-the-art electronic control circuit cuts the power supply to the motor calculating the correct
torque in response to 3 parameters; voltage, frequency and current, according to the selected options.
The AC 90÷260V - 50÷60Hz power supply is converted into 40VDC required by the PLUTO series
screwdrivers through a switching board.
Torque setting
Model Torque (Nm)
Speed (rpm)
Unit %
Min Max


MITO15 0,35-1,5 450 850


PLUTO 3 0,5-3 370 1300


PLUTO 6 0,85-6 200 850


PLUTO 10 1.5-10 110 600


PLUTO 15 2-15 60 320


PLUTO 20 3-20 50 200


PLUTO 35 3-35 40 140


PLUTO 50 5-50 20 90


PLUTO 3 ANG 0.5-2.5 370 1300


PLUTO 6 ANG 1-6 200 850


PLUTO 8 ANG 1,5 - 8 110 600

PLUTO 15 ANG 2-13 100 320

PLUTO 20 ANG 3-18 60 200

PLUTO 30 ANG 6-30 30 130

PLUTO 45 ANG 10-45 20 90

PLUTO 70 ANG 15-70 20 50
IMPORTANT: EDU 2AE/TOP is a highly accurate unit but it is critically important to select the
correct options to ensure that proper torque is being applied. Read the menu description carefully and
in case you are unsure please contact Kolver for support information.
The EDU 2AE / TOP control units can be set in two operating modes:
•%: the tightening and unscrewing torque values are set through a percentage;
• #: the tightening and unscrewing torque values are set directly as the desired value and in the selected unit
of measurement.
Turn the unit on through the on/off switch on the back panel. The unit will carry a general system check and
the words “waiting connection” will appear on the last line of the display. If the connection with the motor
control board is successful the following screen will be displayed: