Why does my Kolver FAB display “Protection 12A”?
The “Protection 12A” message on your Kolver Control Unit indicates that the current on the mosfets of bridge H is greater than 12 A for at least 1 second. To resolve this: * Reduce the cycle rate and check settings. * Avoid motor stalling. * Avoid unscrewing too heavily. * Check if the joint is too soft.
How to resolve “Compensation error” on Kolver Controller?
If the Kolver Controller displays “Compensation error” and a negative torque value is shown due to a high negative compensation value, increase or decrease the compensation value.
What to do if my Kolver FAB displays “Output Disabled”?
The “Output Disabled” message on your Kolver Control Unit means that the protection of output signals was activated after exceeding the maximum load (400mA). To fix this: * Check that the set load does not exceed the maximum value. * Restart the control unit to reset the error.
What causes 'Reverse torque error' on Kolver Control Unit and how to fix it?
The 'Reverse torque error' on your Kolver Control Unit indicates that the torque signal is displayed while loosening (only if set on 'max'). This can happen because: - The screwdriver couldn’t loosen. - You should avoid motor stalling. - Loosening is too heavy.
What to do if Kolver Controller warns “Warning! No piece”?
If the Kolver Controller displays “Warning! No piece” and the “missing piece” contact is enabled, check contact 2 on the CN2 connector.
What causes “Error loosen torque” on Kolver Controller?
If the Kolver Controller displays “Error loosen torque”, it means the torque signal is displayed while loosening (only if it’s set on “max”). This can happen if: - The screwdriver couldn’t loosen. - You should avoid motor stalling. - Loosening is too heavy.
Why does my Kolver Control Unit display 'Protection 12A'?
The 'Protection 12A' message on your Kolver Control Unit indicates that the current on the mosfets of bridge H is above 12A for at least 1 second. Here’s what you can do: - Decrease screwing time and check settings. - Avoid motor stalling. - Don't make unscrewing too heavy. - Check if the joint is too soft.
What to do if Kolver Power Supply displays “Error Torque Control”?
If the Kolver Power Supply displays “Error Torque Control”, create a new screw. If the error persists, adjust the torque and speed settings.
How to fix “Protection 12A” error on Kolver Power Supply?
When the status bar of your Kolver Power Supply displays “Protection 12A”, it means the current on mosfets of bridge H is exceeding 12A for at least 1 second. To fix this: - Decrease the screwing time and check the settings. - Avoid motor stalling. - Ensure unscrewing isn't too heavy. - Verify the joint isn't too soft.
What does “Protection 14p5A” mean on my Kolver Power Supply?
The message “Protection 14p5A” on the Kolver Power Supply status bar indicates that the current on mosfets of bridge H is greater than 14.5 A for at least 800 ms. To resolve this issue: - Decrease the screwing time and check the settings. - Avoid motor stalling. - Ensure that unscrewing is not too heavy. - Check if the joint is too soft.
General| Brand | Kolver |
|---|---|
| Model | FAB Series |
| Category | Control Unit |
| Language | English |
To Next Page
