Komatsu D475A-3 - Check after Stopping Engine

.
OPERATION
OPERATION
STOPPING ENGINE
NOTICE
If
the
engine
is
abruptly
stopped
before
it
has
cooled
down,
engine
life
may
be
greatly
shortened.
Consequently,
do
not
abruptly
stop
the
engine
apart
from
an
emergency.
In
particular,
if
the
engine
has
overheated,
do
not
abruptly
stop
it
but
run
it
at
medium
speed
to
allow
it
to
cool
gradually,
then
stop
it.
1.
Place fuel control dial (1) in the low idling (MIN) position and run
the engine at low idling speed for about 5 minutes to allow it to
gradually cool down.
2. Place fuel control lever (1) in the engine stop position and stop
the engine.
3.
Remove the key of starting switch (2).
CHECK AFTER STOPPING ENGINE
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, and check also
for leakage of oil or water. If any abnormalities are found, repair them.
2. Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.
3 - 94