Komatsu D475A-3 - Every 500 Hours Service

.
MAINTENANCE
SERVICE PROCEDURE
EVERY 500 HOURS SERVICE
Maintenance for every 250 hours service should be carried out at
the same time.
CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE AND BYPASS FILTER CARTRIDGE
(including engine by-pass filter cartridge)
WARNING
The
oil
is
at
high
temperature
after
the
engine
has
been
operated,
so
never
change
the
oil
immediately
after
finishing
operations.
Wait
for
the
oil
to
cool
down
before
changing
it.
Refill capacity: 121 liters (31.97 US gal)
Socket wrench, filter wrench.
1. Remove the covers at the bottom left at the front of the
machine and on the side face, and put a container directly
underneath to catch the drained oil.
2. Remove drain plug (1) and loosen drain valve (2) slowly to
avoid getting oil on yourself, and drain the oil.
Take care not to loosen drain valve (2) so much that the
stopper pin in the valve is distorted.
Tightening torque for drain plug (1): 68.6 ± 9.81 N·m
(7 ± 1 kgf·m, 50.6 ± 7.2
lbft)
Tightening torque for drain valve (2): 63.7 ± 14.7 N·m (6.5 ±
1.5 kgf·m, 47.0 ± 10.8
lbft)
3.
Check the drained oil, and if there are excessive metal particles of foreign material, please contact your Komatsu
distributor.
4. Tighten drain valve (2), then tighten plug (1).
4 - 52