.
PRECAUTIONS FOR OPERATION
Park the machine on level ground where there is no danger of
falling rocks or landslides, or of flooding if the land is low, and
lower the work equipment to the ground.
If it is necessary to park the machine on a slope, set the blocks
under the tracks to prevent the machine from moving, then dig
the work equipment into the ground.
After stopping the engine, operate the right work equipment
control lever several times to the RAISE and LOWER positions
to release the remaining pressure in the hydraulic circuit.
When leaving the machine, set the safety lock lever and parking
lever to the LOCK position, stop the engine, and use the key to
lock all the equipment. Always remove the key and take it with
you.
Work equipment posture: See "PARKING MACHINE (PAGE
3-108)".
Locks: See "LOCKING (PAGE 3-110)"
Always close the door of the operator's compartment.
To Next Page
Loading...
