.
EXPLANATION OF COMPONENTS
ADJUSTING FRONT-REAR POSITION OF RIPPER CONTROL LEVER
(Range of adjustment: ± 40 mm (1.6 in))
The position can be adjusted to suit the operator. The procedure
is as follows.
Adjusting within range of 40 mm (1.6 in) from neutral to rear
1. Using a wrench, loosen lock bolt (1).
2. Set lever (2) to the most suitable position.
3. Tighten lock bolt (1) with the wrench to hold the lever (2) in
position.
Adjusting within range of 40 mm (1.6 in) from neutral to front
1. Remove lock bolt (1).
2. Remove lever (2) and turn it 180°.
3. Install lever (2) to lever (5), then set it to the most suitable
position.
4. Tighten lock bolt (1) with the wrench to hold lever (2) in
position.
5. Loosen nut (3).
6. Turn knob (4) 180°.
7. Tighten nut (3)
PIN PULLER CONTROL SWITCH (IF EQUIPPED)
This is used to operate the pin puller.
(a)PULL OUT: Pin is pulled out.
(b)PUSH IN: Pin is pushed in.
To Next Page
Loading...
