Kone V3F18 - APPENDIX A. Returning the Initial Settings

V3F25/18 drive
Installation Instruction
© 2004 KONE Corporation AM-11.65.020
All rights reserved. 34 (42) (E) 2004-01-08
APPENDIX A. Returning the initial settings
Step Action Note
1 Turn the value of Resolver angle
(6_61)
parameter to 0.
This is recommended when you do not
know the status of the settings of the
HCB board.
2 Turn the value of
Initial settings (6_98)
parameter to 1.
3 Switch the power OFF and ON.