RA83/84/85/93/94/95 Series Chapter4
Operation Manual Installation
Chapter 4
Installation
Contents
Page No.
4.1 Installation considerations................................................. 4-1
4.2 Unpacking each component of the system...................... 4-1
4.3 Inspection of each component unit and accessories...... 4-1
4.4 Setting the units.................................................................. 4-1
4.4.1 Antenna Unit..........................................................................................4-1
4.4.2 Processor and Operation Unit ...............................................................4-2
4.5 Cable routing and connections ......................................... 4-2
4.5.1 Antenna .................................................................................................4-2
4.5.2 Processor Unit.......................................................................................4-2
4.6 Installation procedure......................................................... 4-3
4.6.1 Installing the Transceiver Unit................................................................4-3
4.6.2 Fitting the Aerial.....................................................................................4-4
4.6.3 Connecting the cable.............................................................................4-5
4.6.4 Installing the Processor Unit and Operation unit....................................4-7
4.6.4.1 Table mounting ......................................................................................4-7
4.6.4.2 Flush mounting....................................................................................4-10
4.6.5 Connecting the cable to the Processor unit.........................................4-12
4.6.6 Link setting for the gyrocompass.........................................................4-13
4.6.7 Ferrite core assembling for Power cable .............................................4-14
4.7 Setting up after installation.............................................. 4-15
4.7.1 Transmission timing.............................................................................4-15
4.7.2 Ship’s heading setup ...........................................................................4-16
4.7.3 Resetting Manual GAIN/STC (Height)/Manual STC ............................4-16
4.7.3.1 Manual GAIN setting ...........................................................................4-16
4.7.3.2 STC (Height) setting ............................................................................4-17
4.7.3.3 Manual STC setting.............................................................................4-18
Contents1 93142105-02
To Next Page
