Before Making Copies
3
3-23
Precautions for Loading Paper
G
Be sure to stick to the paper specifications for each tray, i. e., the paper
type, paper size, and capacity, as a paper misfeed could result
otherwise.
G
When loading paper of the inch system (Letter, Legal etc.) in the tray,
change “Paper Auto Detection” of the User’s Choice. (p.7-9)
G
The Inch lamp lights if paper of the inch system (Letter, Legal etc.) is
loaded in the tray.
G
When loading paper of a nonstandard size in the 1st Tray, set “Custom
Size Input” of the Utility mode. (p.7-14)
G
When loading paper of a nonstandard size in the Bypass Tray, perform
the “Custom Size Input (Bypass Tray)” procedure under “Making
Copies.” (p.5-9)
G
When loading Cards, OHP transparencies, or postcards in the 1st
Tray, change “Paper Type (1st Tray)” of User’s Choice. (p.7-9)
G
When loading Cards, OHP transparencies, or postcards in the Bypass
Tray, change “Paper Type (Bypass Tray)” of User’s Choice. (p.7-9
)
G
To disable APS or Auto Tray Switching with recycled paper loaded in
the tray, change “Special Paper Setting” of User’s Choice. (p.7-9)
G
When loading paper of any FLS size other than the default setting (210
mm × 330 mm), setting by your Tech. Rep. is necessary.
For how to load paper, refer to “When the Add Paper Indicator Lights up.”
(p.8-4)
Konica7115_7118.book Page 23 Tuesday, October 16, 2001 10:51 AM
To Next Page
