Using the Utility Mode
7
7-1
7 Using the Utility Mode
The Utility mode offers the following subfunctions.
Calling the Utility Mode to the Display
1
Hold down the [AUTO RESET] key
for 3 seconds.
2
Check that “U--” appears on the
Display.
3
Using the Key Pad, enter the code
corresponding to the desired
subfunction.
E.g.: Enter “1” to make a setting for
User’s Choice.
4
Press the [START] key.
Code Name Description
1 User’s Choice Allows you to select the default setting for each of
the various functions.
2 Drum Dehumidify Removes dewdrops that have formed on the
surface of the PC Drum.
3 Toner Replenisher Replenishes the supply of toner to make up for a
lower toner-to-carrier ratio.
4 Custom Size Input Sets a custom size for the 1st Tray if it is loaded
with paper of a nonstandard size.
5 Administrator Mode Allows the administrator of the copier to make
settings for operating and maintaining the copier.
Konica7115_7118.book Page 1 Tuesday, October 16, 2001 10:51 AM
To Next Page
