User's Guide
- 141 -
Memory low, no Resource Save [35]
Try one or more of the following:
• From the printer control panel, press
to disable Resource Save, clear the message, and
continue printing.
• Install additional printer memory.
Non-Printer Manufacturer [supply type], see User’s Guide [33.xy]
Note: The supply type can either be a toner cartridge or imaging unit.
The printer has detected a non-Printer Manufacturer supply or part installed in the printer.
Your KONICA MINOLTA printer is designed to function best with genuine Printer Manufacturer supplies
and parts. Use of third-party supplies or parts may affect the performance, reliability, or life of the printer
and its imaging components.
All life indicators are designed to function with Printer Manufacturer supplies and parts, and may deliver
unpredictable results if third-party supplies or parts are used. Imaging component usage beyond the
intended life may damage your KONICA MINOLTA printer or associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage
caused by the use of third-party supplies or parts are not covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your
printer, press
and on the printer control panel simultaneously for 15 seconds to clear the
message and continue printing.
If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and
then install a genuine KONICA MINOLTA supply or part.
Note: For the list of supported supplies, see the “Ordering supplies” section of the User's Guide.
Network error, port [x] [54]
Try one or more of the following:
• From the printer control panel, press
to clear the message and continue printing.
• Unplug the router, wait for 30 seconds, and then plug it back again.
• Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or the print server.
To Next Page
Loading...
