EasyManuals Logo

Konica Minolta bizhub 3301P User Manual

Konica Minolta bizhub 3301P
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
User's Guide
- 51 -
- Have postage stamps attached
- Have any exposed adhesive when the flap is in the sealed or closed position
- Have bent corners
- Have rough, cockle, or laid finishes
Adjust the width guides to fit the width of the envelopes.
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal
envelopes.
Tips on using labels
Print samples on the labels being considered for use before buying large quantities.
Note: Use only paper label sheets. Vinyl, pharmacy, and two-sided labels are not supported.
When printing on labels:
Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify
that:
- The labels can withstand temperatures up to 240°C (464°F) without sealing, excessive curling,
wrinkling, or releasing hazardous emissions.
- Label adhesives, face sheet (printable stock), and topcoats can withstand up to 172-kPa (25-psi)
pressure without delaminating, oozing around the edges, or releasing hazardous fumes.
Do not use labels with slick backing material.
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam.
Partial sheets also contaminate the printer and the cartridge with adhesive, and could void the printer
and toner cartridge warranties.
Do not use labels with exposed adhesive.
Do not print within 1 mm (0.04 inch) of the edge of the label, of the perforations, or between die-cuts
of the label.
Make sure the adhesive backing does not reach to the edge of the sheet. Zone coating of the
adhesive should be at least 1 mm (0.04 inch) away from edges. Adhesive material contaminates the
printer and could void the warranty.
If zone coating of the adhesive is not possible, then remove a 2-mm (0.08-inch) strip on the leading
and driver edge, and then use a non-oozing adhesive.
Portrait orientation is recommended, especially when printing bar codes.
Tips on using letterhead
Use letterhead designed specifically for laser printers.
Print samples on the letterhead being considered for use before buying large quantities.

Table of Contents

Other manuals for Konica Minolta bizhub 3301P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Konica Minolta bizhub 3301P and is the answer not in the manual?

Konica Minolta bizhub 3301P Specifications

General IconGeneral
BrandKonica Minolta
Modelbizhub 3301P
CategoryPrinter
LanguageEnglish

Related product manuals