35
Click the scan button in the main window to start the final
scan. If the DiMAGE Scan Utility was opened in an image-
processing application, the scanned image will be opened
in that application. If the utility is used by itself, the save
as dialog box will open.
On the save-as dialog box, enter the file name, and select
the file destination and file format for the image data. If
multiple images are scanned, a serial number can be
added to the file name automatically; click the add-num-
ber check box and then enter the first number of the
series. When saving JPEG files, the compression ratio
must be specified. Click the save button to make the final
scan.
A file type used in Macintosh. This file can be opened in the Simple Text applica-
tion installed with Macintosh operating systems. The file cannot have a width
greater than 4096 pixels.
PICT
A file type used in Windows. This file type can be opened in the paint software
installed in the Windows operating system.
BMP
A high-resolution bitmap that can be opened on any computer platform. The
color depth can be specified in the preference window (p. 45).
TIFF
This file can be compressed to reduce the file size. The compression ratio can
be selected when saving. The higher the compression ratio, the smaller the file
size, and more loss to image quality.
JPEG
When the Job file is loaded, a cropping frame will appear on the image. The frame is proportion-
al to the output use specified with the Job. The frame can be resized, but the proportions will
remain the same; the input and output values are automatically adjusted to match the change to
the cropping frame.
Click a Job file name to select it. The Job names can be
sorted chronologically or alphabetically by clicking the
name or date radio buttons at the bottom of the dialog
box.
The scan settings of the selected Job file are displayed on
the right side of the window. The Job settings vary with
the film format. Click the OK button to apply the Job set-
tings.
To Next Page
Loading...
Need help?
General
