Korg A5 - Creating Original Programs; [Manual;Edit Mode]

CREATING ORIGINAL PROGRAMS
[Manual/Edit Mode]
About "Parameters” and "Editing”
Changing the settings of individual effects such as the balance between direct sound and effect output is called "editing". "Parameters”
are the specific settings inside each effect with values that are changeable for “editing”.
Editing of parameters can be done in two ways:
1)Find a program that sounds closest to what you want, and create your own by editing that program.
2)Pick any program in the user area, and start from scratch.
While you are new to this unit, it is probably easier and faster to edit using method (1).
BANK1 | PROGRAM || PROGRAM2 | | PRoGRAM3 PROGRAMS ] <= Write
User area(This area can
BANK2 PROGRAMI | | PRoGRAM2 | | PROGRAM3 | | PROGRAM4 | | PROGRAMS hold edited programs.)
BANK3 |PROGRAM: | | PRogRAM2 | | PROGRAM3 PROGRAMS
BANK4 PROGRAMI | | PROGRAM2 | | PROGRAM3 | | PRoGRAM4 | | PROGRAMS Cia
Find a program closest
BANKS PROGRAMI | | PRogRAMz | | PROGRAM3 | | PROGRAMA | | PROGRAMS to the sound you want.
BANK8 PROGRAM! || PRoGRAM2 | | PROGRAM3 | | PROGRAMA | | PROGRAMS
1.Enter the Program mode and find a program that sounds The parameters in the program are set as below, for example.
closest to what you want. The figure below shows selecting
program 1 in Bank 2, for example. (See page 4.)
2-1 METAL I =
2.Enter the Edit mode by pressing the Mode Select Switch. Distortion 3Bend
The Mode LED's, the Value Display and the EFCT/PROG
LED's will change to indicate the Edit mode.
Effect Parameter ius