36
Moving to a locate point
When you press a previously-registered [IN/LOC1],
[OUT/LOC2], [TO/LOC3], or [END/LOC4] key, you
will move to the registered location.
Using marks to move the time location
You can register a specific location in a mark, and then
move instantly to the registered location.
A name can be assigned to each mark, and used to nav-
igate within a song.
Up to 100 marks can be registered in each song.
Registering a mark
1 Move the current time to the location that you
wish to register as a mark.
Use the counter or the [FF]/[REW] keys to change
the current time.
2 Press the [STORE] key to capture the time loca-
tion.
3 Register the time location you captured.
Press the [MARK] key to register the captured time
location as a mark. The registration will be com-
pleted at the moment you press the key. Marks will
be renumbered in order of time.
Even if you perform steps 2 and following
during playback or recording, the time loca-
tion at the moment you pressed the [STORE]
key will be captured, and can be registered in a
mark.
Moving to a mark location
1 Access the [MARK] “Mark” tab page.
2 Use “MarkNumber
” to select the desired mark.
3 Select the “Recall” button, and press the [ENTER]
key to recall the mark.
You will move to the time location of that mark.
Deleting a mark
Undo is not available after deleting a mark.
1 Access the [MARK] “Mark” tab page.
2 Use “MarkNumber
” to select the mark that you
wish to delete.
3 Select the “Delete” button and press the [ENTER]
key to access the dialog box.
4 Verify the “mark number to be deleted” in the
upper left. If you wish to delete it, select the
“Yes” button and press the [ENTER] key to delete
it. If you decide not to delete it, select the “No”
button and press the [ENTER] key.
To delete all marks, select the “SelectAll” button
and press the [ENTER] key to turn it “On.” (Steps
2 and following are not necessary.) Then select the
“Yes” button and press the [ENTER] key to delete
the marks.
Naming a mark
• Select the “Rename” button and press the [ENTER]
key to access the “RenameMark” dialog box. For the
rename procedure, refer to “2. Naming a song”
(→p.21).
• When you have assigned a name, select the “OK”
button and press the [ENTER] key.
3. Using scrub playback etc. to find
a precise time location
By using the Scrub function, the Play From/To func-
tion, or the Slow Play function, you can more accu-
rately find a location where the sound begins, or set a
locate time or mark time with greater precision.
Using the Scrub function
1 Press the [TRACK STATUS] key of the track that
you wish to search, setting its track status to PLAY
(LED lit green).
2 Press the [SCRUB] key to turn the Scrub function
“On” (key lit).
3 Use “TrackSelect” to select the track that you
wish to play.
4 Select “Loc,” and rotate the [VALUE] dial to find
the location while listening to the audio.
The track audio will play back in correspondence
with the rotation of the [VALUE] dial.
To Next Page
Loading...
Need help?
General
