Sequencer mode
478
Enable JS+Y [Off, On]
Specifies whether or not MIDI CC#1 (the +Y axis of the
OASYS’s joystick, or a Modulation Knob Assign
setting) will be received.
Enable JS–Y [Off, On]
Specifies whether or not MIDI CC#2 (the –Y axis of the
OASYS’s joystick, or a Modulation Knob Assign
setting) will be received.
Enable Ribbon [Off, On]
Specifies whether or not MIDI CC#16 (the OASYS’s
ribbon controller, or specified as the assignment of a
realtime modulation knob) will be received.
Track 02…16 (Track Number)
These are the MIDI Filter 1 settings for MIDI tracks 2
through 16. They are the same as for track 1. See “Track
01:”.
▼ 3–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Rename Song. For more information, see
“Rename Song” on page 524.
• 3: Delete Song. For more information, see “Delete
Song” on page 524.
• 4: Copy From Song. For more information, see
“Copy From Song” on page 524.
• 5: Load Template Song. For more information, see
“Load Template Song” on page 524.
• 6: Save Template Song. For more information, see
“Save Template Song” on page 525.
• 7: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525
• 8: Set Location (for Locate Key.) For more
information, see “Set Location (for Locate Key)” on
page 525.
• 9: GM Initialize. For more information, see “GM
Initialize” on page 526.
• 10: Copy From Combination. For more
information, see “Copy from Combination” on
page 526.
• 11: Copy From Program. For more information, see
“Copy From Program” on page 526.
To Next Page
Loading...
