Sequencer mode
502
(Note Map Keyboard Track) [Off, On]
Note Map Table Display
For more information, see “Note Map” on page 106.
▼ 7–3: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 408.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525.
• 8: Set Location (for Locate Key). For more
information, see “Set Location (for Locate Key)” on
page 525.
• 9: Copy From Program. For more information, see
“Copy From Program” on page 526.
7–4: Module Parameters-Trigger
Here you can specify the trigger parameters for each
KARMA Module, and whether it will be latched.
7–4a: Module Parameter-Trigger
Control
Quantize Trigger [Off, On]
Update On Release [Off, On]
Please see “Control” on page 108.
Delay
Delay Start [Off, Fixed, 64T …4x1]
Delay Start Fixed [0000ms…5000ms]
Please see “Delay” on page 108..
Note
Note Trigger [Any, AKR, 1st, Dyn]
Note Latch [Off, On]
Please see “Note” on page 109. and p.382.
1–1a
7–4a
7–4PMC
To Next Page
Loading...
