Korg Electronic Keyboard - 28: Od;Hypergain Wah

Overdrive, Amp models, and Mic models 028: OD/HyperGain Wah
789
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
028: OD/HyperGain Wah
This distortion effect has two modes: overdrive and
hyper-gain that produces a strong distortion. A higher
high-gain setting is required for this effect relative to a
normal-size effect.
WAH
Wah Switch [Off, On]
Source [Off…Tempo]
Mode [Toggle, Moment]
These parameters let you turn the Wah on and off from
either the LCD or a controller, and determine how the
controller works. For more information, see “Wah
Switch” on page 788.
Sweep Range [–10…+10]
Source [Off…Tempo]
These parameters set the modulation source and
amount for the Wah. For more information, see “Wah
Sweep” on page 788.
DRIVE
Pre Low-cut [0…10]
This attenuates low frequencies before the signal enters
the distortion. Use this to create a sharper tone.
Drive Mode [Overdrive, Hyper-Gain]
Switches between overdrive and hyper-gain mode.
Drive [1…120]
Sets the degree of distortion. For more information, see
“DRIVE” on page 788.
Direct Mix [0…50]
Amount of the dry sound mixed to the distortion.
Speaker Simulation [Check-box]
Speaker simulation on/off.
Output Level [0…50]
Sets the output level. For more information, see
“DRIVE” on page 789.
Source [Off…Tempo]
Selects the modulation source for the output level.
Amount [–50…+50]
Sets the modulation amount of the output level.
EQ
Low Fc [Hz] [20…1.00k]
Sets the center frequency for Low EQ (shelving type).
Gain [dB] [–18…+18]
Sets the gain of the Low EQ.
Mid1 Fc [Hz] [300…10.00k]
Sets the center frequency for Mid/High EQ 1 (peaking
type).
Q [0.5…10.0]
Sets the band width of Mid/High EQ 1. p.773.
Gain [dB] [–18…+18]
Sets the gain of Mid/High EQ 1.
Mid2 Fc [Hz] [500…20.00k]
Sets the center frequency for Mid/High EQ 2 (peaking
type).
Q [0.5…10.0]
Sets the band width of Mid/High EQ 2. p.773.
Gain [dB] [–18…+18]
Sets the gain of Mid/High EQ 2.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Amp Simulation
3 Band EQ
Output Level
Direct Mix
Pre Low-cut
D
-mod
Wah
Mode: Overdrive / Hyper-Gain
Drive
Driver
+