Korg Electronic Keyboard - 124: Limiter - Multitap Delay; 125: Exciter - Comp

Mono-Mono Serial 124: Limiter - Multitap Delay
865
Resonance [+/–100]
Sets the resonance amount. p.805.
Output Mode [Normal, Wet Invert]
Selects whether the phaser output is mono or pseudo-
stereo. For more information, see “Output Mode” on
page 857.
When Routing is set to Phaser
→→
→→
Comp, Output Mode
will automatically be set to Normal.
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the phaser effect balance. p.780, p.804.
Source [Off…Tempo]
Selects the phaser’s Wet/Dry modulation source.
Amount [+/–100]
Sets the phaser’s Wet/Dry modulation amount.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
124: Limiter - Multitap Delay
This effect combines a mono limiter and a multitap
delay. You can change the order of the effect s.
Routing
Routing [Limiter ➝ Mt.Delay, DLY ➝ Limiter]
Switches the order of the limiter and multitap delay.
LIMITER
Ratio [1.0 :1…50.0 :1, Inf :1]
Sets the signal compression ratio. p.765.
Threshold [dB] [–40…0]
Sets the level above which the compressor is applied.
p.766.
Attack [1…100]
Sets the attack time. p.766.
Release [1…100]
Sets the release time. p.766.
Gain Adjust [dB] [–Inf, –38…+24]
Sets the limiter output gain. p.766.
MULTITAP DELAY
Tap1 Time [msec] [0.0…1360.0]
Sets the Tap1 delay time.
Tap2 Time [msec] [0.0…1360.0]
Sets the Tap2 delay time.
Tap1 Level [0…100]
Sets the Tap1 output level. p.832.
Feedback [+/–100]
Sets the Tap2 feedback amount.
High Damp [%] [0…100]
Sets the damping amount in the high range. p.829.
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the multitap delay effect balance.
Source [Off…Tempo]
Selects the multitap delay’s Wet/Dry modulation
source.
Amount [+/–100]
Sets the multitap delay’s Wet/Dry modulation
amount.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
125: Exciter - Comp
This effect combines a mono exciter and a compressor.
You can change the order of the effects.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
Multitap Delay
Feedback
High Damp
Delay
(2)
(1)
Mt.Dly Wet / Dry
Limiter
Limiter
Gain Adjust
Envelope - Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
Compressor
LEQ HEQ
EQ Trim
Comp
Output Level
Envelope - Control
Exciter
Exciter