Effect Guide
774
012: Stereo Graphic 7EQ
This is a stereo 7-band graphic equalizer. The bar
graph of the gain setting for each band gives you a
clear, visual idea of frequency responses. You can select
a center frequency setting for each band from twelve
types, according to the sound.
GRAPHIC EQ
Type [1:Wide 1, 2:Wide 2, 3:Wide 3,
4:
Half Wide 1,
5:
Half Wide 2,
6:
Half Wide 3,
7:Low, 8:
Wide Low,
9:Mid, 10:
Wide Mid,
11:High, 12:
Wide High]
This parameter selects a combination of center
frequencies for each band. Each center frequency is
shown on the bottom of the Gain slider.
You can configure a 21-Band Graphic EQ ranging from
80Hz to 18kHz if you route three Graphic 7Band EQ
effects in series, with a setting of 7:Low, 9:Mid, and
11:High for each EQ.
Trim [0…100]
Sets the input level
(Band1…8 Gain [dB]) [–18.0…+18.0]
These controls set the gain for each of the eight bands.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
013: Stereo Master 3EQ
This is a stereo three-band equalizer. The Low EQ and
High EQ gain can be controlled in real-time.
You can use this as a TFX to make final adjustments to
the sound.
PARAMETRIC EQ
Trim [0…100]
Sets the input level.
Low Fc [Hz] [0…980]
Sets the cutoff frequency of the Low EQ (shelving
type).
Gain [dB] [–18.0…+18.0]
Sets the gain of the Low EQ.
Mid Cutoff [Hz] [100…10.00k]
Sets the cutoff frequency of the Mid EQ (peaking type).
Q [0.5…10.0]
Sets the bandwidth of the Mid EQ
Gain [dB] [–18.0…+18.0]
Sets the gain of the Mid EQ.
High Cutoff [Hz] [500…20.00k]
Sets the cutoff frequency of the High EQ (shelving
type).
Gain [dB] [–18.0…+18.0]
Sets the gain of the High EQ.
GAIN MOD
Low Source [Off…Tempo]
Selects the source that will modulate the Low Gain.
Amount [dB] [–36.5…+36.0]
Sets the amount by which the Low Gain will be
modulated.
High Source [Off…Tempo]
Selects the source that will modulate the High Gain.
Amount [dB] [–36.5…+36.0]
Sets the amount by which the High Gain will be
modulated.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Band1 Band2 Band3 Band4
Trim
Trim
Band5 Band6 Band7
Band1 Band2 Band3 Band4 Band5 Band6 Band7
D
-mod
D
-mod
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Low
LEQ
High
HEQ
Trim
Mid
PEQ
Trim
To Next Page
Loading...
