Program P5: Split & Drawbars 5–1: Keyboard Split
219
Program P5: Split & Drawbars
You can set up the organ to use a single sound across
the entire keyboard, or to split the keyboard between
two different sets of drawbars.
5–1: Keyboard Split
5–1a: Split
Split Enable [Off, On]
This turns the split on and off.
When Split is Off, only the Upper drawbars will be
used.
AMS [List of AMS Sources]
This allows you to assign an AMS source to toggle the
split on and off.
For a list of AMS sources, see “AMS (Alternate
Modulation Source) List” on page 967.
AMS Mode: [Momentary, Toggle]
This determines the behavior of Split Enable AMS. For
details, see “AMS Mode” on page 218.
Split Point [C-1…G9]
This sets the highest key of the lower split range.
Upper Octave Shift [-2 octaves…+2 octaves]
This raises or lowers the pitch of the Upper drawbars
in one-octave steps.
Lower Octave Shift [-2 octaves…+2 octaves]
This raises or lowers the pitch of the Lower drawbars
in one-octave steps.
▼ 5–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
5–1PMC
5–1a
To Next Page
Loading...
