Sequencer P7: KARMA 7–5: GE Real-Time Parameters
503
Envelope1, Envelope2, Envelope3
Envelope Trigger [Any, AKR, 1st, Dyn]
Envelope Latch [Off, Sus1, Rel1, Sus2, Rel2]
Please see “Envelope1, Envelope2, Envelope3” on
page 109.
Module Trigger
Trigger By Module [Off, A, B, C, D]
GE Phrase Length [000…100%]
Cutoff Module A, B, C, D [Off, On]
Please see “Module Trigger” on page 382.
▼ 7–4: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 408.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525.
• 8: Set Location (for Locate Key). For more
information, see “Set Location (for Locate Key)” on
page 525.
• 9: Copy From Program. For more information, see
“Copy From Program” on page 526.
7–5: GE Real-Time Parameters
Here you can edit the Real-Time Parameters of the GE
for each KARMA Module [A]–[D]. In addition, you can
assign GE Real-Time Parameters to the KARMA Real-
Time Controls so that you can control the phrase or
pattern in real-time while you play.
7–5a: GE No. & Name, GE RTC Select,
Tempo
GE Number & Name
This indicates the number and name of the GE that is
selected for each KARMA Module.
GE RTC Select [1–16, 17–32]
For more information, see “GE RTC Select” on
page 110.
7–5a
7–5b
7–5c
7–5PMC
To Next Page
Loading...
