Sequencer P9: Master/Total Effect 9–1: Routing
521
Sequencer P9: Master/Total Effect
Here you can make settings for the master effects and
total effects. For more information, please see “Effect
Guide” on page 727.
9–1: Routing
Here you can specify the type of master effects and
total effects, and turn them on/off.
The master effects are sent to the L/R bus. The total
effects are inserted into the L/R bus.
These parameters are the same as in Program mode.
For more information, please see “9–1: Routing” on
page 134.
9–1a: MFX1, 2
MFX1:
MFX1 [000…185]
MFX1 On/Off [Off, On]
Return 1 [000…127]
MFX2:
MFX2 [000…185]
MFX2 On/Off [Off, On]
Return 2 [000…127]
Chain:
Chain On/Off [Off, On]
Chain Direction [MFX1→MFX2, MFX2→MFX1]
Chain Level [000…127]
9–1b: TFX1, 2
TFX1:
TFX1 [000…185]
TFX1 On/Off [Off, On]
TFX2:
TFX2 [000…185]
TFX2 On/Off [Off, On]
9–1c: Master Volume
Master Volume [000…127]
▼ 9–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
1–1b
9–1a
9–1b
9–1c
9–1PMC8–5b
To Next Page
Loading...
