KARMA GE guide
944
“Chord Quantize (RT)” setting of 0: Off. This may or
may not be desirable; sometimes you may want it,
other times you may not. When “Chord Quantize
(RT)” is set to 1: On, the notes in the first repeat of the
chord will be hard quantized so that they generate
simultaneously. All subsequent repeats will be based
on those quantized notes, and therefore will also be
quantized.
When “Key Mode (RT)” is 1: Up
The repeats will be triggered when the key(s) are
released, so they will be quantized together at that
point to occur simultaneously anyway, with no “slop.”
But depending where you released them overall in
time, they may be “out of sync” with the rhythm or
groove that may be being generated. This corresponds
to the “Chord Quantize (RT)” setting of 0: Off. When
“Chord Quantize (RT)” is set to 1: On, the release (and
generation of the first repeats) will be quantized to
correspond to the nearest rhythmic division of note
generation. This will either be a 16th note, or the
rhythm value chosen in the “Rhythm Value”
parameter, whichever is longer.
To Next Page
Loading...
