J - i J>. - J>J)J> J) - J)J)
9. Play the chord (‘F’, ‘A’, ‘B’, ‘E’) again and release it, to
enter a “16th chord” (S# = 021).
1. Put the Sequencer into WRITE mode as described above.
2. Play ‘G’ (above middle C), hold it, press the STEP switch
once, and release the key, to enter ‘G’ as an 8th note.
The Step Number Display should now read “SCS3”(S#
= 003).
3. Play and hold ‘A’, press STEP once, and release the key
to enter “A” as an 8th note (S# = 005).
4. Press the STEP switch four times, without holding any
keys down, to insert a quarter rest (S# = 009).
5. While holding down a chord (‘F’, ‘A’, ‘C’, ‘E’), press STEP
twice and then release the keys, to enter the chord with
a length of a dotted 8th note (a “dotted 8th chord”) (S #
= 012).
6. Play the chord (‘F’, ‘A’, ‘C’, ‘E’) again and release it, to
enter it as a “16th chord” (S# = 013).
7. Press the STEP switch four times, without holding any
keys down, to insert a quarter rest (S# = 017).
10. Press the STEP switch twice by itself, to insert a 8th rest
(S# = 023).
11. Play ‘G’ and press STEP once to enter an 8th note
(S# = 025).
12. Play ‘A’ and press STEP once to enter an 8th note
(S# = 027).
13. Play ‘C’ and press STEP once to enter an 8th note
(S# = 029).
II III II
14. Play ‘D’ and press STEP once to enter an 8th note
(S# = 031).
II III II
8. While holding down a chord (‘F’, ‘A’, ‘B’, ‘E’), press STEP
twice and then release the keys, to enter as a “dotted
8th chord” (S# = 020).
15. Play ‘E’ and press STEP once to enter an 8th note
(S# = 033).
To Next Page
Loading...
Need help?
General
