Korg Karma - Page 88

- 88 -
(5) Now you can see the individual banks of sounds. Cursor to Bank C.
Press Utility and “Load Selected”. When the dialog comes up, Load it
into Bank C.
(6) Press [Up] to go back up one level. Cursor to Combinations. Press
[Open].
(7) Now you can see the individual banks of sounds. Cursor to Bank C.
Press Utility and “Load Selected”. When the dialog comes up, Load it
into Bank C.
(8) Press [Up] to go back up one level. Cursor to Drum Kits. Press
[Open].
(9) Now you can see the individual banks of drum kits. Load 16-31 into
16-31 (Bank C).
You should be set at this point, with all your Karma settings back in
Banks A,B,E, and with your EXB stuff in Banks C. As I already
explained elsewhere, Banks C & D are completely identical for the EXB
boards and you don’t need to load both (except for the new Orchestral
Board, which has 2 banks of sounds. Just repeat the above procedure
again, substituting “D” for “C”).
If you want some extra banks of Triton sounds (all playing the same GE,
since no GEs are assigned), you can use the above procedure modified to
load Banks A/B from the EXB floppy into Banks D/F of the Karma.
3. How do I add GEs (along with Realtime Control settings) to an
EXB Program or Combi?
If you assign GEs to a Program/Combi from an expansion board, there
aren’t any knob assignments because no one created them. But you can
copy these from another Program/Combi using the “Copy KARMA
Module” Utility.
Example - copying the KARMA Settings from Program A001:
AcousticPiano AT
- Go to your EXB Program Bank(s) and select a Piano Program.
- (6.1-1) [Menu]->[KARM]->[Setup]->[Utility]->“Copy KARMA Module”
- Select Program A001.
- Make sure that [x] KARMA RT & Panel Setting is checked.
- Press OK.
You’ve now copied everything related to KARMA from one Program to
another. ☞ Parameter Guide, Page 26.