- 89 -
It works in a similar fashion copying from a Combi, but you can specify
which module (A,B,C, or D, or All) that you wish to copy.
4. How do I install the expansion board itself?
☞ Parameter Guide Pages 264-265.
5. Can I load EXB data (.PCG) for Expansion Boards that I do not
own?
The expansion boards contain ROM Waveform data. The new Program
data that comes with the board in the C and/or D Bank use these
Waveforms. If you load the data, but do not have the board installed, the
Programs can be selected, can be examined, can be played, but they will
sound WRONG (with possibly a few exceptions). In other words, any
Program that uses the EXB waveforms will sound WRONG unless the
board is installed. Maybe you will like one or two of them anyway ;-)
The Combi data in the new Combis will use Programs from the preload
A/B Program banks, and also many programs from the new bank. If the
board is not installed, many Combis will have timbres that sound wrong,
because they are pointing at Programs that sound wrong. Other timbres
may sound fine, since they will be pointing at A/B Programs.
So it is possible you could load data for which you do not have the
expansion board, and find a few new Combis and Programs that sound
good. But most of them will be “broken”.
6. I bought EXB PCM03 – Future Loop Construction. Where are all
the Drum Patterns and Loops?
This board uses the RPPR function to create all the Drum Patterns.
What you need to do is load the song file from the disk (Future Loops
disk) that matches the bank that you loaded the loops into.
Go into sequencer mode, enable RPPR and choose one of the 16 or 17
songs. The loops and hits are mapped across the keyboard.
7. When I try to change a timbre in a Combi to use one of the F
Bank MOSS Programs, that Program doesn’t work!
MOSS programs have a special “Voice Reserve” setting, that defaults to
"0" in the Combi.
Select COMBI (2.3-1) [Menu]-[MOSS]-> Voice Reserve.
To Next Page
Loading...
Need help?
General
