KingKORG Parameter Guide
Effects
-
29 -
EQ
EQ is an effect that lets you adjust the volume of the high- and
low-frequency ranges.
You can use it to improve the balance of the sound, or to adjust
the final output appropriately for the acoustics of your
performance space or the response of your audio system.
This is a shelving-type two-band parametric equalizer that allows
you to change the cutoff frequency.
HIGH..............................................................[–15dB…0dB…+15dB]
LOW .............................................................. [–15dB…0dB…+15dB]
Adjusts the gain of each band.
Using the knob will change the volume in the region of the center frequency.
Turning the knob toward the right of center will boost that region, and turning it
toward the left will attenuate that region.
EQ High (High EQ Freq.) .................................[1.00kHz…20.00kHz]
EQ Low (Low EQ Freq.). .............................................. [20…1000Hz]
Adjust the cutoff frequency of each band.
TIP:
You can adjust each cutoff frequency by holding down the SHIFT/EXIT button and turn-
ing the HIGH knob or LOW knob.
TIP:
The HIGH and LOW cutoff frequencies can be set in Global mode. They can also be
saved as global settings. →Writing the global settings (OM: p.21 “1. Saving global set-
ting” )
TIP:
These settings cannot be saved for each program.
To Next Page
Loading...
Need help?
General
