-
37 -
KingKORG Parameter Guide
MIDI
Mod Harm values for VPM oscillators OSC1, 2, and 3
The following table shows the control change values that are transmitted and
received when you edit the “Mod Harm” parameter of the variable phase
modulation oscillator, and how the control change value corresponds to the
parameter value.
Value (transmitted, received) Mod Harm
0…3 0.5
4…7 1
8…11 2
12…15 3
16…18 4
19…22 5
23…26 6
27…30 7
31…34 8
35…38 9
39…42 10
43…46 11
47…49 12
50…53 13
54…57 14
58…61 15
62…65 16
66…69 17
70…73 18
74…77 19
78…80 20
81…84 21
85…88 22
89…92 23
93…96 24
97…100 25
101…104 26
105…108 27
109…111 28
112…115 29
116…119 30
120…123 31
124…127 32
SyncNote values when LFO 1/2 TempoSync is “On”
The LFO 1/2 Freq. parameter will change to “SyncNote” if TempoSync is on.
The following table shows the control change values that are transmitted or
received in this case, and how they correspond to the parameter value.
Value (transmitted, received) LFO Sync Note
0…7 8meas
8…14 4meas
15…22 2meas
23…29 1/1
30…37 3/4
38…44 1/2
45…52 3/8
53…59 1/3
60…67 1/4
68…74 3/16
75…82 1/6
83…89 1/8
90…97 1/12
98…104 1/16
105…112 1/24
113…119 1/32
120…127 1/64
Delay Time values for MOD DELAY and BPM DELAY
Value (transmitted, received) LFO Sync Note
0…9 1/32
10…27 1/16
28…45 1/8
46…63 1/6
64…81 3/16
82…99 1/4
100…117 3/8
118…127 1/2
EQ Gain values
The following table shows the correspondence between the parameter values
edited by the EQ HIGH knob and EQ LOW knob and the control change values
that are transmitted or received.
Value
(transmitted, received)
EQ Gain
(dB)
Value
(transmitted, received)
EQ Gain
(dB)
0…2 –15.0 66, 67 0.5
3, 4 –14.5 68, 69 1
5, 6 –14.0 70, 71 1.5
7, 8 –13.5 72, 73 2
9, 10 –13.0 74, 75 2.5
11, 12 –12.5 76, 77 3
13, 14 –12.0 78, 79 3.5
15, 16 –11.5 80, 81 4
17, 18 –11.0 82, 83 4.5
19, 20 –10.5 84…86 5
21…23 –10.0 87, 88 5.5
24, 25 –9.5 89, 90 6
26, 27 –9.0 91, 92 6.5
28, 29 –8.5 93, 94 7
30, 31 –8.0 95, 96 7.5
32, 33 –7.5 97, 98 8
34, 35 –7.0 99, 100 8.5
36, 37 –6.5 101, 102 9
38, 39 –6.0 103, 104 9.5
40, 41 –5.5 105…107 10
42…44 –5.0 108, 109 10.5
45, 46 –4.5 110, 111 11
47, 48 –4.0 112, 113 11.5
49, 50 –3.5 114, 115 12
51, 52 –3.0 116, 117 12.5
53, 54 –2.5 118, 119 13
55, 56 –2.0 120, 121 13.5
57, 58 –1.5 122, 123 14
59, 60 –1.0 124, 125 14.5
61, 62 –0.5 126, 127 15
63…65 0
To Next Page
Loading...
Need help?
General
