Parts and their functions
3
Parts and their functions
Top panel
1. Mixer section
MIC IN jack (XLR jack)
Connect a dynamic mic here.
Condenser mics are incompatible with the KR-55 Pro.
INPUT 1 jack, INPUT 2 jack
Connect a guitar, bass, or other instrument to these jacks.
TUNER button
Turns the tuner function on.
ACOUSTAGE button
Switches the Acoustage (wide) function on/o.
The Acoustage function cannot be used while recording.
Turn the Acoustage (wide) function o when using
headphones. The Acoustage function is optimal when
connecting stereo speakers to the OUTPUT L/MONO and
R jacks.
Power button
Turns the power on.
See page 8 “Turning the power on/o”
2: HOT
3: C
Note: The power buon blinks rapidly if the baeries become
low while the KR-55 Pro is running on baeries.
The KR-55 Pro has an auto power-o function. The auto
power-o function automatically turns o the power when
there has been no user input for a certain length of time (which
you can specify). If the auto power-o function has turned the
power o, simply turn it back on again.
Tip: You can specify the time after which the auto power-o
turns the power o (see page 23 “[M3] Auto power-o
function “APOF””).
MIC knob, peak LED
This knob adjusts the input level from the mic that’s connected
to the MIC IN jack. To avoid signal clipping (signal that’s
too loud) this knob should be adjusted so that the peak LED
doesn’t light up when signal is being input at a high volume
level.
(INPUT) 1 knob, (INPUT) 2 knob, peak
LED
These knobs adjust the input level from the instruments that
are connected to INPUTS 1&2. To avoid signal clipping (signal
that’s too loud) each knob should be adjusted so that the peak
LED doesn’t light up when signal is being loudly input.
The peak LED is shared by INPUT 1 and INPUT 2. If you’re
using both input jacks, adjust the knobs for both INPUT 1 &
INPUT 2.
1. Mixer section
2. Select section
3. Control section
3-a: Mode buttons
3-b: Function buttons
3-c: Control buttons, VALUE dial,
Display
To Next Page
Loading...
