Model SSD size
KRONOS 30 GB
KRONOS X 62 GB
Advance it to the following inspection pushing the [ENTER] switch.
11. Fan Control
LCD displays “Value” and “RPM”
Confirm that “RPM” value is change by VALUE slilder.
(note) If “RPM” value is not change, rotate encoder more than two clicks.
Advance it to the following inspection pushing the [ENTER] switch.
(The following notes added from the KRONOS(K4-) & KRONOS-X.)
(Note) Confirm that there are more than 1000 (RPM) is a difference in the display when the
display Value 127 and 0 .
When the system is in V2.0.1and mother board is D510MW, the difference in rotational
speed is good in more than 800.
12 All LED check
Check all red LED turn on.
Check that the brightness of LED is uniform.
Wite LED
Top of Joystick Bottom of Joystick Left of Joystic Right of Joystick
SW1 SW2 KARMA ON/OFF LATCH
M A B C D
LINK ED DRUM TRACK TIMBRE/TRACK
RED LED
Advance it to the following inspection pushing the [ENTER] switch.
13. Panel SW & LED check
The confirmation advances in order of the table below.
Push the switch corresponding to lighting LED.
(note) Refer to the table below for the correspondence of the switch and LED.
To Next Page
Loading...
