15-6 Rotary Encoder Check
Confirm rotate smoothly.
Set the encoder to the position that you easily get one rotation.
Push switch [7] for reset.
Rotate one-rotation encoder clockwise.
Confirm an increase of the value and becoming 32.
Confirm that “OK” is displayed under “32”
Push switch [7] for reset.
Rotate one-rotation encoder counterclockwise.
Confirm an decrease of the value and becoming -32.
Confirm that two “OK” is displayed under “-32”
Push [ENTER] and advance it to the following inspection after the confirmation ends.
15-7 TEMPO Volume Check
Rotate smoothly
“OK” is displayed right side of “CENTER” when the knob is rotated 12 o’clock.
“OK” is displayed right side of “MAX” when the knob is rotated clockwise full.
“OK” is displayed right side of “MIN” when the knob is rotated counterclockwise full.
It advances to the following inspection at the same time.
15-8 Pedal
Push on the opponent of EXP-2.
Push on the near side of EXP-2 slowly.
Confirm three OK is displayed in the next order.
1) “OK” is displayed under “MIN” of “FootPedal”
2) “OK” is displayed under “CENTER” of “FootPedal”
3) “OK” is displayed under “MAX” of “FootPedal”
Push on the opponent of EXP-2.
Push DS-1H slowly.
Confirm three OK is displayed in the next order.
1) “MAX” of “DamperPedal”
2) “CENTER” of “DamperPedal”
3) “MIN” of “DamperPedal”
Release DS-1H
Push PS-2
Confirm that “OK” is didplayed under “MIN” of “FootSwitch!”
Release PS-2
To Next Page
Loading...
