EnglishFrançaisDeutschEspañol
Rear panel and connections
En-7
Audio output jacks
Mic input jack
Line input jack
Power button
Power supply jack (DC 9V)
Cord hook
AC
1
2
3
4
5
6
7
98
456
7
8
12
1 2 3
SD card slot
USB B port
9
AC adapter
(Included)
a. DC plug
b.
c.
to an
AC outlet
MIDI IN/OUT connectors
E
SD card
MIDI keyboard
MIDI IN MIDI OUT
MIDI cable
USB cable
Computer
Audio player, etc.
Mic
Monitor
Amplier, etc.
INPUT
Foot switch jack
You can use a pedal switch (separately sold) to switch
sounds or to start/stop the sequencer.
Foot pedal jack
You can use a foot controller (separately sold) to control the
volume or tone.
Using batteries
Batteries that can be used
Use six AA nickel-metal hydride batteries or alkaline
batteries. Zinc-carbon batteries cannot be used.
Continuous operating time
Alkaline batteries will allow approximately four hours of
usage. Battery life will depend on the type of batteries and
on the conditions of use.
Do not mix new and old batteries, or batteries of
differing types. Mixing batteries in this way may cause
them to leak or burst.
If the batteries are exhausted, remove them
immediately. Exhausted batteries may leak or burst if
you leave them installed.
Installing batteries
Note: Batteries are not included. You’ll need to obtain them
separately.
1. Remove the battery compartment cover
The battery compartment of the KROSS-61 is located
on the bottom panel. When turning the unit upside
down, place it on a blanket or similar material to
prevent damage to the knobs and dials.
2. Installing batteries
When inserting the batteries, make sure that you observe
the correct polarity (“+” and “–”).
Note: The
illustration shows
the KROSS-61.
Note that on the
KROSS-88, the
batteries are
oriented in the
opposite way.
3. Close the battery compartment cover
Close the cover by reversing the steps you took to remove
it.
Specifying the type of batteries that you installed
After you’ve installed the batteries, turn on the power and
specify the type of batteries you’re using.
a. Press the GLOBAL/MEDIA button to enter
GLOBAL/MEDIA mode.
b. Press the PAGE+ (or PAGE-) button to access the
GLOBAL > PREF (Preferences) page.
c. Press the cursor button (or ) to select the Battery
Type parameter, and press the ENTER button to switch the
setting.
Alkaline batteries: Alkaline
Nickel-metal hydride batteries: Ni-MH
d. Save the settings (see “Saving your settings (Global
Settings)” on page 8.)
Battery remaining indication ( , , )
An indicator in the upper right of the screen shows the
remaining battery capacity. If you’re using the AC adapter,
this will indicate .
Note: If is flashing, the batteries are almost exhausted.
Immediately save any important data, and either install fresh
batteries or switch to using the AC adapter.
KROSS-61
While pressing the latch,
pull upward and remove
KROSS-88
While pressing from above the
on the cover, slide it away
from yourself and remove
To Next Page
Loading...
Need help?
General
