Korg nanoKEY Studio User Manual

16
MIDI messages from the Knobs.
When set to “Global”, MIDI messages will be transmitted on the
Global MIDI Channel, specified in the global parameters.
CC Number ........................................................... [0...127]
This parameter specifies the CC number of the control change
message that will be transmitted.
Left Value ............................................................. [0...127]
This parameter specifies the value of the control change mes-
sage that is transmitted when you turn the Knob fully to the
left.
Right Value ............................................................ [0...127]
This parameter specifies the value of the control change mes-
sage that is transmitted when you turn the Knob fully to the
right.
Touchpad (Touch Scale mode)
MIDI Channel ............................................. [1...16, Global]
This parameter specifies which MIDI channel is used to transmit
MIDI messages when using the Touchpad in the Touch Scale
mode. When set to “Global”, MIDI messages will be transmitted
on the Global MIDI Channel, specified in the global parameters.
Y-axis Enable .......................................... [Enable, Disable]
This parameter specifies whether to enable or disable the trans-
mission of control change messages when you move your fin-
ger along the Y-axis in the Touchpad.
Y-axis CC Number ................................................. [0...127]
This parameter specifies the value of the control change mes-
sage that will be transmitted.
Y-axis Lower Value ................................................ [0...127]
This parameter specifies the value of the control change mes-
sage that is transmitted when you touch the bottom edge of the
Touchpad.
Y-axis Upper Value ............................................... [0...127]
This parameter specifies the value of the control change mes-
sage that is transmitted when you touch the top edge of the
Touchpad.
Touchpad (X-Y Control mode)
Toutch/Release
CC
CC
Touchpad
CC
CC
Touchpad
X-axis/Y-axis
MIDI Channel ............................................. [1...16, Global]
This parameter specifies which MIDI channel is used to transmit
MIDI messages when using the Touchpad in the X-Y Control
mode. When set to “Global”, MIDI messages will be transmitted
on the Global MIDI Channel, specified in the global parameters.

Korg nanoKEY Studio Specifications

General

Pad color	White
Knobs color	Black
Control type	Buttons, Rotary
Number of pads	8
Backlight buttons	Yes
MIDI-keyboard number of keys	25 keys
Interface	USB
Battery type	AAA
Power source type	Battery, USB
Number of batteries supported	2

Weight and Dimensions

Depth	160 mm
Width	278 mm
Height	33 mm
Weight	471 g