KORG PA-80 Demonstration and Sales Guide
16
Saving Your New Performance
Okay, we are done customizing our set-up. Now its time to save our work as a PERFORMANCE. By saving
as a PERFORMANCE, we can instantly recall it later, and with all of our edits intact.
1. Press the WRITE DISK IN USE button.
2. Select the PERF.NAME feature by pressing the DRUM-PERC/DRUM edit key.
3. The Cursor is flashing over the first letter of the name. Use the value wheel to select a new
number or letter.
4. Use the DOWN/- and UP/+ keys to move through the letters of the name, adjusting each with
the value wheel.
5. Finish naming your PERFORMANCE.
6. Now select PERF.N: (PERFORMANCE number) by pressing the BASS/PERC edit key. In
addition to naming our PERFORMANCE, we need to store it in a numbered location.
7. Using the Value wheel, dial up location number 10-8 (the Performance TAKE VOICES is stored
there now).
8. Press ENTER/YES.
9. Are you sure? Press ENTER/YES again.
You have successfully created a new PERFORMANCE Set-Up! Congratulations!
Using your New Performance
1. Return to the STYLE PLAY mode.
2. To the far right of the PA-80, select the PERFORM. button. To the left of this button is the
STYLE CHANGE button; turn it on as well.
3. Using the PROGRAM/PERFORMANCE select buttons, choose bank 0 (the furthest to the right).
4. The performance you just created is saved at the bottom right of the DISPLAY. Select this
PERFORMANCE using the LOWER/ACC5 edit key.
5. Press EXIT/- to return to the STYLE PLAY mode.
6. Press the big, red START/STOP button and play along! Now you can use this new
PERFORMANCE to record a new Song or Backing Sequence; or to simply play.
To Next Page
Loading...
Need help?
General
