28
Here’s how to restore the SDD-3000 PEDAL to its factory-set state.
This procedure will initialize the programs you’ve saved, returning all of them to the factory-set
programs.
During initialization, do not touch any of the device’s knobs, buttons or foot switches. In addition,
do not turn off the device.
1. Press and hold the WRITE button and R TIME button and connect a cable to the INPUT
(L/MONO) jack.
2. Press the WRITE button when “Inlt” blinks on the TIME/VALUE display.
The initialization of the program will start. When initialization is complete, “CPLt” will appear
on the display.
To cancel the initialization, press the EXIT button.
Restoring the factory settings
To Next Page
Loading...
