Korg SDD-3000 PEDAL - Front Panel Overview; Switches and Foot Switches

7
Front panel
Programmable sections of the SDD-3000 PEDAL
Since the area indicated in the illustration is controlled by a CPU, 80 programs (40 banks×2) can be
saved. These programs consist of seings for the delay type, delay time, regeneration, modulation,
eect (BALANCE), ducking and pedal assignment in addition to MIDI and system seings (basic
SDD-3000 PEDAL seings).
1. SWITCH
1. TAP/BANK DOWN foot
switch
Use this foot switch to set the
delay time. Press the TAP/
BANK DOWN switch two
times. The interval of time
between the two buon presses
will be set as the delay time.
In bank selection mode, pressing
this foot switch will decrease the
bank number.
2. BANK UP foot switch
In bank selection mode, pressing
this foot switch increases the
bank number.
1
2 3
3. Channel A and B foot
switches
Use these foot switches to
choose the channel for the
selected bank.
Also, pressing the foot switch
for the selected channel turns
o (bypasses) the eect.
See page 17 “Selecting a pro-
gram”.
* The shaded part (
) of
the illustration indicates the
part of the SDD-3000 PEDAL
that’s described in this section.