54
3
© 2020 KOSTAL Solar Electric GmbH
Installation
After commissioning, further settings can be configured
using the KOSTAL Smart Energy Meter’s online interface.
To do this, use your PC or tablet to log into the KOSTAL
Smart Energy Meter. You will find a detailed description
in
Ch. 4.
The following settings should be configured by the
installer after the initial commissioning:
n
Configure prescribed settings relating to the grid
feed-in/power limitation specified by the energy sup-
ply company (e.g. for dynamic limitation for PIKO 4.2
- 20, PIKO EPC and for multiple-inverter connection
of solar inverters) if this has not already been done in
the inverter.
n
Log into the KOSTAL Solar Portal. In this case, the
measurement data is transmitted from the KOSTAL
Smart Energy Meter to the portal
n
Set date / time
n
Update device firmware Ch. 5.4
n
Change password of KOSTAL Smart Energy Meter.
This can be done by going to “Profile” > “Change
password”
Ch. 5.5
IMPORTANT
INFORMATION
To log in, you will need the password
from the energy meter’s type plate,
which can be found on a separate
instruction leaflet in the packaging.
INFO
You only need to log into the KOSTAL
Solar Portal when using PIKO MP
plus with a battery or using KOSTAL
solar inverters in a multiple-inverter
connection.
3.7 Configuring settings in the Webserver
To Next Page
Loading...
