MAINTENANCE
TRACK PLANT MAINTENANCE PROCEDURES
180
4. Check engine coolant level.
5. Add coolant if necessary.
6. Install coolant cap.
R
ELATED LINKS:
Lockout/Tagout Procedure
Engine Drive Belts
1. Lockout/tagout the plant, following all local rules and regulations.
2. Inspect engine drive belts for excessive wear or damage.
3. Replace or re-tension belts as necessary.
NOTICE: See the engine manual for the proper coolant specifications. Do NOT use any sealants that are not
recommended by your engine manufacturer.
To Next Page
Loading...
