SETUP
TRANSPORTING MACHINERY
61
Moving the Plant
The track-mounted crushing plant is designed to be moved around a site under its own power. To move the
plant you will need to read and understand the safety precautions explained in this manual as well as all site
safety regulations applicable to operating a crushing plant.
Plant Travel Pre-Start Checks
1. Read and understand the operations manual.
2. Check the engine oil level.
3. Inspect the engine air cleaner and clean intake evacuator valve.
4. Examine the engine radiator and hydraulic cooler fins for material build up.
5. Check the engine fuel level.
6. Check the hydraulic oil level.
7. Visually inspect the hydraulic hoses and connections.
8. Make sure the cone travel blocks are properly installed in the crusher.
9. Prepare all conveyors for traveling, which could include lowering or folding into travel mode.
10. Install conveyor shipping brackets or tie down conveyors, where applicable.
WARNING: You must make all bystanders aware that the plant is about to be moved.
Serious injury or death can occur if an individual is in the path of the moving plant. As
the operator, it is your responsibility to use the warning horn while operating the plant.
NOTICE: You must install the cone travel blocks before moving the plant. Failure to install the travel blocks in the
crushing chamber will cause severe damage to the bearings and will void the crusher warranty.
To Next Page
