REFERENCE INFORMATION
CRUSHER INFORMATION
435
K300+ Product Capacities
Open circuit capacities in tons-per-hour
Minimum closed side setting is the closest setting possible that does not induce bowl float. Actual minimum
closed side setting and production numbers will vary from pit to pit and are influenced by such factors as
nature of feed material, ability to screen out fines, manganese condition, and low relief system pressure.
OPEN CIRCUIT CAPACITIES IN TONS-PER-HOUR
CSS
1/2”
(13mm)
5/8”
(16mm)
3/4”
(19mm)
7/8”
(22mm)
1”
(25mm)
1-1/4”
(32mm)
1-1/2”
(38mm)
1-3/4”
(44mm)
2”
(51mm)
K300+ Gross
Thoughput
170-210
(154-191
mtph)
190-240
(172-218
mtph)
215-270
(195-245
mtph)
240-300
(218-272
mtph)
270-330
(245-299
mtph)
310-385
(281-350
mtph)
330-415
(299-376
mtph)
350-440
(318-399
mtph)
370-460
(335-417
mtph)
CLOSED CIRCUIT CAPACITIES IN TONS-PER-HOUR
CSS 1/2” (13mm) 5/8” (16mm) 3/4” (19mm) 7/8” (22mm) 1” (25mm) 1-1/4” (32mm)
K300+ Net
Product
145-179
(131-162 mtph)
162-204
(147-185 mtph)
178-224
(162-203 mtph)
192-240
(174-218 mtph)
213-261
(194-237 mtph)
223-277
(202-251 mtph)
CSS 3/8” (10mm) 1/2” (13mm) 5/8” (16mm) 3/4” (19mm) 7/8” (19mm) 1” (22mm)
1-1/4”
(32mm)
K300+
Recirculating
Load
15% 15% 15% 17% 20% 21% 28%
NOTICE: Estimated results may differ from published data due to variations in operating conditions and application
of crushing and screening equipment. This information does not constitute an expressed or implied warranty, but
shows estimated performance based on machine operation within recommended design parameters. Use this
information for estimating purposes only.
To Next Page
